Comments:
   This is the third and final use of Obverse 3 and the first of two uses of Reverse D.
Reverse D has not been found in any other years.
|
Obverse 3
The following photo shows the Obverse 3 attribution grid. The date position is virtually identical to obverse 1.
The only slight difference is the date grid. The right base of the 1 is RE on Obverse 1, JL of RE on Obverse 3.
1870-CC Obverse 3 attribution grid
Obverse 3 is similar to Obverse 1, but exhibits few markers that allow easy identification (die state a, seen only
on the OC-4 die marriage, is an exception, with major die markers. These are shown in the description of OC-4).
The most obvious features are the LACK of any of the markers described for obverse 1. In addition there is a light
die line in the shield that can be noted on mid- to high-grade examples. This feature is shown on the next photo.
1870-CC Obverse 3 die line in shield recesses
The line is very light, but still visible in the picture. It arcs across shield recesses 5, 6, and 7, extending to the
border of the shield. It should be visible under medium to high magnification, 10-power or more, for coins grading
XF40 or higher. It probably won’t be visible on lower grades.
Obverse 3 Die States
- Perfect die.
- Die polishing has eliminated most of the die lines and significantly reduced the unfinished area under the chin.
OC-6 is has been found only with obverse die state b.
|
Reverse D
The following photo shows the attribution lines for 1870-CC Reverse D.
1870-CC Reverse D attribution lines
Reverse D is the second of two close CC reverses. Mintmark positions are slightly different, but not enough to be
notable to the eye. The distinguishing feature is the presence (or lack of) a die line extending from the lower
tip of the upper arrow feather. The two reverses are compared in the composite photo below. The arrow in the top
picture points to the die line on Reverse D. The square in the bottom photo shows the same area, and lack of
the die line, on Reverse B. The presence of this die line, or lack of its presence, can be determined on examples
grading as low as VG. Reverse B was used to strike OC-3 and OC-5. Reverse D was used to strike OC-6 and OC-7.
1870-CC Reverse B (lower) and Reverse D (upper)
Reverse D Die States
- Perfect die.
No later die states have been observed.
|